Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Determining mounting method
WARNING:
personal injury, mount to outlet box marked acceptable for
fan support of 15.9 Kg (35 lbs) or less and use mounting
screws provided with the outlet box.
If there is not an existing UL Listed metal mounting box,
then read the following instructions. Disconnect the power
by removing fuses or turning off circuit breakers.
Secure the outlet box directly to the building structure. Use
appropriate fasteners and building materials. The outlet
box and its support must be able to fully support the moving
weight of the fan (at least 35 lbs.). Do not use plastic outlet
boxes. Figures 1 and 2 are examples of different ways to
mount the outlet box.
ceiling joist, you may need an installation hanger bar as
shown in Figure 3 (available at your Retailer).
Outer Box
Figure 1
THD_UC42V-NI/WH-SHC_UC195-YI_Eng
Outer Box
Figure 2
Outer Box
Figure 3
Installing the support bar
NOTE: You may need a longer downrod to maintain proper
blade clearance when installing on a steep, sloped ceiling.
The maximum angle allowable is 18° away from horizontal. If
the canopy touches the downrod, then remove the decorative
canopy bottom cover (C) and turn the canopy (B) 180° before
attaching the canopy (B) to the mounting bracket (A).
REMEMBER to turn off the power. Follow the steps below to hang
your fan properly.
Secure the supporting bar to the ceiling outlet box as
shown in Figure 4 by using two screws and washers (not
provided). Make sure the supporting bar is level. You may
need to insert additional washers (not provided) between
the outlet box and the supporting bar to make it level.
Outer Box
Before making the electrical connections, use the square
hole at one end of the supporting bar (A) to hang the fan
motor (Figure 5).
5
Figure 4
A
Figure 5
18年7月04日 下午17:00
Publicidad
