Erbauer EPM18-Li Instrucciones Originales página 30

After use
1. Switch the product off, remove the battery back and let it cool down.
2. Check, clean and store the product as described below.
WARNING! Always switch the product off, remove the battery back and
let the product cool down before performing inspection, maintenance and
cleaning work!
Only perform care and maintenance work according to these instructions!
All further works must be performed by a qualified specialist!
Clean
1. Clean the product with a dry cloth. Use a brush for areas that are hard to reach.
2. In particular clean the switches and air vents after every use with a cloth and brush.
3. Remove stubborn dust with high pressure air (max. 3 bar).
4. Check for worn or damaged parts. Replace worn parts as necessary or contact an
authorised service centre for repair before using the product again.
5. Clean the mixer paddle in a bucket of clean water, using a brush to remove mix
residue. Dry paddle after cleaning.
NOTE: Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be harmful
to its surfaces.
30
MNL_Erbauer_18V DC Paddle Mixer_EPM18-Li_V2_220117 II.indd 30
Care & maintenance
1/17/22 12:21 PM