Publicidad
Idiomas disponibles
Idiomas disponibles
Skin care - Plasma mode
Preparation
Before the treatment, you should remove makeup, thoroughly cleanse your skin and then pat it dry.
ANTI-ACNE TREATMENT
Holding the device, make circular motions on the area with acne. After 10 seconds, perform the treatment on the next area of skin
with acne. In case of areas requiring intensive care, repeat the treatment 2-3 times. After the treatment, use a skin tonic and a
serum. The last step of the skin care is to gently massage in a cream.
SKIN REGENERATION/INTENSIVE REJUVENATION
Holding the device, move it slowly from bottom to top in the direction indicated by the arrow. The movement from the starting point
to the end point should last approximately 3-5 seconds. The treatment should be repeated 3-5 times. After the treatment, do your
daily skin care according to your skin's needs and your habits. Do not perform any skin care treatments too close to your eyes or
throat.
Guidelines:
1.
When using the device for the first time, it is recommended to select a low setting and limit the time of use to 2-3 minutes for the
entire face. During consecutive treatments, it is recommended to progressively switch the device to higher settings and increase
the time of use. Do not use the device for longer than 10 minutes for the entire face during one session.
2.
An effect of using the device will be increased absorbability of beauty products. Thus, you should choose beauty products proper
for your skin, remembering to avoid products containing alcohol or stronger acids.
3.
It is recommended to use the device as a final step of evening care. Use of the device during the day requires protection of the
face with a strong SPF filter.
4.
Sound and smell will be emitted during use of the device. It is a natural phenomenon occurring during the generation of plasma,
which does not require any additional action.
5.
The charging port must be closed with the silicone plug during the treatment.
Purpose
Acne treatment
Rejuvenation / Deep skin permeability
Peeling mode
• Wet your skin with water before starting the treatment.
• Do not press the spatula firmly against the skin or apply it repeatedly to the same area.
• If your skin starts to dry out during the treatment, it should be wet with water again.
Tilt the back of the spatula against the skin at a 30° angle and move it upwards in the direction indicated by the arrow.
Pay attention to the direction of the spatula's movement.
Area of use
Acne areas
Face
Surface of the
skin
Time of use
5-10 minutes
Guidelines:
• It is the best to use the device when the
External
skin is warm: after a bath or after applying a
power
hot towel on your face.
button
• After using the device, take care of your
skin applying a tonic.
EN
Frequency
1-2 times a day
Once a day
Publicidad
