Argo AFIAS11DC V2 Instrucciones De Uso página 9

3742540641-U-AFIA-BS11DC-V2
ADJUSTING THE AIR FLOW DIRECTION
HORIZONTAL (manual)
The horizontal air flow can be adjusted by moving the
vertical vanes to the left or right, as indicated in the following
figures.
This air conditioner is equipped with two air outlet grilles:
the upper grille with flap and the lower grille.
Grasp here
VERTICAL (with remote control unit)
Make sure that the remote control unit has been turned on.
the FLAP button to select the flap function
Fixed:
six
position
20-07-2015 8:46
Grasp here to
move the vanes
Upper grille
Lower grille
Press
Continous Automatical
oscillations oscillations
Pagina 9
The flap automatically closes when the unit
l
NOTES
is off.
When the unit starts in heating operation,
l
the fan stops and the flap is in the 4 position
(if automatical oscillation is selected) until
the air being blown out of the unit begins to
warm. Once the air warms up, the flap
position and fan speed change to the settings
specified with the remote control.
CAUTION
Do not move the flap with your hands when the air
conditioner is running.
CAUTION
• Use the FLAP button on the remote control to adjust
the position of the flap. If you move the flap by hand,
the factual flap position and the flap position on the
remote control may no longer match. If this should
happen, shut off the unit, wait for the flap to close,
and then turn on the unit again; the flap position will
now be normal again.
• Do not have the flap pointed down during cooling
operation. Condensation may begin to form around the
air vent and drip down.
Only upper grille
HOW TO ADJUST THE FLAP DIRECTION
COOL
DRY
HEAT
FAN
CAUTION
Set vertical vanes to the front position during
COOLING/DRY operation if humidity is high.
If the vertical vanes are set to the left-most or right-most
position, condensation will form around the air outlet
and drip off.
9
EG