Velleman VDL4DL Manual

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying this 4" rotating disco light! Read this manual carefully before bringing the device into service. Make sure that the device
was not damaged in transit. If the device is damaged, you should contact your dealer and postpone installation of this device.
2. Safety Instructions
Protect this device against rain and moisture.
Unplug the supply cable before you open the housing.
• Damage caused by disregarding certain guidelines in this manual is not covered by the warranty and the dealer will not accept
responsibility for the ensuing defects or problems.
• Do not switch the device on immediately if it has been exposed to changes in temperature. Protect the device against damage by
leaving it switched off until it has reached room temperature.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage from sharp edges. Ask an authorised dealer to replace the cord if necessary.
• Always disconnect the device from the mains when it is not in use or when you wish to clean it. Only handle the power cord by the plug.
Never pull out the plug by tugging the power cord.
• Do not look directly into the light source as sensitive people may go into epileptic seizure if they do.
• There may be some smoke or a particular smell when the device is activated for the first time. This is normal and the smell will gradually
disappear.
• Note that damage caused by user modifications to the device is not covered by the warranty. Keep the device away from children and
unauthorised users.
3. General Guidelines
• Only operate this device with the supplied power adapter. Do not use the VDL4DL outdoors.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device will be protected against extreme heat, moisture and dust. Respect a min. distance of 50cm between
the projector and the illuminated surface.
• Familiarise yourself with the functions of the device before actually using it. Do not permit operation by unqualified people. Any damage
that may occur will probably be caused by unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• Note that all modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, lamp explosion, crash, etc.
Using the device in an unauthorised way will void the warranty and may damage the device.
4. Installing or Replacing the Lamp
Turn the plastic ball counterclockwise gently while holding the ring between the base and the ball. Remove the old lamp and insert a new
one, screwing it clockwise to fix it. Only install the lamp when the device is unplugged from the mains. Replace the lamp if it is damaged but
take care to let the lamp cool down before you do this.
Do not install lamps with a higher wattage than that for which the device was designed. Use one 12V/5W lamp, E10 socket.
VDL4DL
VDL4DL – 4" ROTATING DISCO LIGHT
1
VELLEMAN