Hitachi RAI-25RPA Manual Del Usuario página 35

MAINTENANCE
CAUTION
Cleaning and maintenance must be carried out by qualiÀ ed service personnel.
Before the cleaning, stop operation and disconnect the power supply.
Clean the À lter at least once every one month. This helps save electricity cost.
1. CLEANING OF AIR FILTER
REMOVAL AND ATTACHMENT OF AIR FILTER
PROCEDURE
1
Remove the À lter from indoor
● Press the mark "PUSH" on the left and
right sides of the suction grille.
● Pull out the À lter from the grille.
2
Remove dust from the À lter using a vacuum
cleaner.
If there is too much dust, use neutral
detergent. After using neutral detergent, wash
with clean water and dry in the shade.
3
Install the À lter. (Set it with "UP SIDE" mark
facing front.)
Slot the À lter to suction grille and close as
original state.
(Press the mark "PUSH" at the left and right
sides of the suction grille to À x it securely.)
Note:
●
This model has an air cleaning À lter. The cooling capacity is slightly weakened and the cooling
speed becomes slower when the air cleaning À lter is used. So, set the fan speed to "HIGH" when
using it in this condition.
CAUTION
● Do not wash with hot water at more than 40°C. The À lter may shrink.
● When washing it, shake off moisture completely and dry it in the shade; do not expose it directly
to the sun. The À lter may shrink.
● Do not operate the air conditioner with the À lter removed. Dust may enter the air conditioner and
cause trouble.
– 9 –