Publicidad
Idiomas disponibles
Idiomas disponibles
Controls
Features and appearance will vary.
Lights below the touch pads on the air conditioner control panel indicate the selected settings.
6
4
5
Air Conditioner Controls
Controls
ower Pad
1. P
Turns air conditioner on and off. When turned on, the
display will show the room temperature.
isplay
2. D
Shows the room temperature or time remaining on the
Delay timer. Shows the Set temperature while setting
the temperature in Cool or Energy Saver modes.
emp and Delay Increase
3. T
can be set in Cool and Energy Saving mode.
ode Pad
4. M
Energy Saver mode.
an Speed Pad
5. F
In Cool, Energy Saving mode:
on the unit.
In Fan Only mode:
on the unit.
4
2
7
/Decrease – Pads
+
Fan Only, Cool, or
Auto, High, Med or Low
High, Med, or Low
Unit power
on/off
Mode select
Fan speed
Delay 1–24hr
Temperature
3
set/Delay Timer
Increase and
Decrease
1
Remote Control
elay Pad
6. D
Shows the room temperature or time remaining on the
Delay timer. Shows the Set temperature while setting
the temperature in Cool or Energy Saver modes.
Delay ON—When the air conditioner is off, it can be
set to automatically come on in 1 to 24 hours at its
previous mode and fan settings.
Delay OFF—When the air conditioner is on, it can be
set to automatically turn off in 1 to 24 hours.
How to set:
Press the Delay 1–24hr pad on the unit or the remote
control. Each touch of the Increase
pads on the unit or the remote control will set the timer
in 1-hour intervals.
To review the remaining time on the Delay 1–24hr
timer, press the Delay 1–24hr pad on the unit or the
pads on the unit or on the remote control to set a new
time if desired.
To cancel the timer, press Decrease
unit or the remote control until the set time is zero.
After 3 seconds the light on the Delay 1-24 hour pad
goes off.
7. Filter Reset Pad
This feature automatically notifies you that the air filter
must be cleaned. The indicator light will come on after
240 hours of operation. Clean the air filter (refer to
page 6), place it back in the front panel, and press the
Filter Reset pad. The light will go off.
Temp / Delay Hrs
-
+
–
/ Decrease
+
–
Increase
/ Decrease
–
pad on the
49-7762
Publicidad
