Publicidad
Idiomas disponibles
Idiomas disponibles
Before
starting
CAUTION:
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box. Turning
power off using the fan switch is not sufficient to
prevent electric shock.
Step 1. Remove the 1 of 3 screws from the posts
of the switch houising and keep it for future use.
Loosen the other 2 screws. (Do not remove) (Fig.
14)
Step 2. While holding the LED light kit under
your fan, make the polarized plug connections:
- White to white
- Black to blue
Step 3. Place the key holes in the LED light kit
over the two screws previously loosened from the
switch houising. Turn the LED light kit until the
LED light kit locks in place at the narrow section
of the key holes. (Fig. 14)
Step 4. Securely tighten the two light kit
mounting screws previously loosened and the one
previously removed. (Fig. 14)
Step 5. Raise glass shade up against the LED
light kit, and secure it to fan by turning light kit
shade
clockwise
until
snug.
OVERTIGHTEN. (Fig. 15)
installation,
Wire connector
Light kit
Figure 14
DO
NOT
Switch housing
Screws
Figure 15
Installing the Light Kit 8.
Switch
housing
Glass
shade
Publicidad
