Descargar Imprimir esta página

Toto Vivian TL220DD12 Manual De Instrucciones Y Del Propietario página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION PROCEDURE - Spout
6.
Orient the spout as needed. From
below the mounting surface, place
the crescent shaped gasket and
washer over the mounting stud as
shown.
Fasten the mounting nut to the
stud to secure the spout.
Tighten with wrench as needed.
7.
Connect each hose to the side port
of each valve. Tighten with wrench.
NOTE: If wrapping the hose(s) in
a loop is needed, be careful not to
crimp the hose at any point as this
could restrict the water flow.
INSTALLATION PROCEDURE - Handles
8.
Orient handle assembly and lower
onto the exposed portion of valve until
engaged. Rotate the base (dome) of the
handle assembly to fasten it to the valve.
Repeat for other handle assembly.
NOTE: If handles do not line up exactly
as desired, remove handle from valve
and reinstall one (1) notch over (on valve).
Fine adjustment may be done by slightly
rotating valve from underneath installed
surface.
9.
Insert the drain lift rod through the
opening in the spout.
5
Mounting Stud
Mounting Stud
Gasket (rubber)
Gasket (Rubber)
Washer (metal)
Washer (Metal)
Mounting Nut
Mounting Nut
Handle Assembly*
Handle Assembly*
Valve
Valve
Drain Lift Rod*
Drain Lift Rod

Publicidad

loading