Publicidad
Idiomas disponibles
Idiomas disponibles
FEATURES
POSITIVE STOPS ON MITER TABLE
SPINDLE
Positive stops have been provided at 0°, 15°, 22.5°, 31.6°,
LOCK BUTTON
and 45° on both the left and right side of the miter table.
SELF-RETRACTING LOWER BLADE GUARD
See Figure 3.
TRIGGER
The lower blade guard is made of shock-resistant, see-
LOCKOUT
through plastic that provides protection from each side of
LEVER
the blade. It retracts over the upper blade guard as the saw
is lowered into the workpiece.
SPINDLE LOCK BUTTON
See Figure 3.
The spindle lock button locks the spindle, stopping the
blade from rotating. Depress and hold the lock button while
installing, changing, or removing the blade.
SWITCH TRIGGER
SWITCH TRIGGER
See Figure 3.
LOWER
BLADE GUARD
The saw will not start until you depress the trigger lockout
lever and squeeze the switch trigger. To prevent unauthorized
use of the compound miter saw, remove the battery pack
from the tool and lock the switch in the off position. To lock
the switch, install a padlock (not included) through the hole in
the switch trigger and make certain the switch is inoperable.
If the switch is still operable with the padlock installed, a
padlock with a larger shackle diameter must be used. Store
the padlock key in another location.
Fig. 3
PAD LOCK
TOOLS NEEDED
The following tools (not included) are needed for making adjustments:
FRAMING SQUARE
COMBINATION SQUARE
Fig. 4
10 – English
Publicidad
