Shark AH400 Manual página 7

MAINTENANCE
To keep your vacuum's suction power optimal, follow these instructions.
IMPORTANT: Allow ALL filters to dry completely before replacing in the vacuum.
Make sure unit is off and cord is unplugged.
STEP 1
EMPTYING THE DUST CUP
1 Detach the removable Dust Cup from the Motorized Floor Nozzle by pressing the Dust Cup Release Foot Pedal located on the left side near the Nozzle�
2 Holding the Dust Cup by the handle, lift it up to remove it from the Motorized Floor Nozzle�
3
Hold the Dust Cup over a garbage bag or can, then press the Empty button on the side of the Dust Cup� The bottom lid will open, allowing the debris to
fall out�
4 Clean the dust screen inside the Dust Cup as required�
Pre-Motor Filters
Filter Access Latch
CLEANING THE FILTERS
Pre-Motor Filters
Access the Pre-Motor Filters by pressing the FILTER ACCESS latch on
the top of the Dust Cup� Remove and rinse the foam and felt filters
every month� Let air-dry COMPLETELY before replacing in the
vacuum� Hand wash only� Tap loose dirt off filters between washes
as needed� Insert the felt filter first, and then place the foam filter on
top of it�
STEP 2
Post-Motor Filter
Access the Post-Motor Filter on the top of the Motorized Floor
Nozzle� Remove and rinse once a year� Let air-dry completely before
replacing� Hand wash only�
RECOMMENDED FILTER CLEANING SCHEDULE:
Pre-Motor Filter Kit (Foam & Felt):
Post-Motor Filter:
1. 8 0 0 . 7 9 8 . 7 3 9 8
STEP 3
Post-Motor Filter
Every month
XFFH400
Every year
XEXFH400
6