Publicidad
Idiomas disponibles
Idiomas disponibles
EN
replaced in good time or there will be a
defective contact between the brushes
and the collector, originating sparks
and damaging the hammer. Both
brushes must be replaced at the same
time by two equal ones.
When the brushes are getting worn, the
brushes' indicator light (15) activates,
indicating the necessity of replacement.
1. Unplug the power cable (9);
2. Untighten the fixing screws and
remove the brushes' access cover (10);
3. Disconnect the brushes connecting
cord;
4. Displace the pin and remove the
worn brushes;
5. Place the new brushes and the pin;
6. Plug the brushes connecting cord;
7. Move the cables inside the cover
to avoid smashing or damaging them
when placing the cover;
8. Tighten the fixing screws;
5.2 - HAMMER LUBRICATION
The hammer doesn't need constant
or daily lubrication once it has an
incorporated
lubrication
However, it is recommended to replace
from time to time the lubricating grease
in order to extend the hammer's
lifespan.
5.3 - CLEANING AND STORAGE
Cleaning
After each use, clean every component
of the machine. Rub the equipment with
a clean and damp cloth or blow it with
low pressure compressed air.
Remove and clean the grease inside the
locking sleeve regularly.
A
careful
handling
protects
equipment and extends its lifespan.
Keep the machine and its ventilation
30
openings unobstructed. Clean them
regularly to avoid clogs.
Storage
When the hammer isn't being used,
it shall be kept inside a dry place,
corrosive steam free and away from
children's reach.
6. ENVIRONMENT
SAFETY
The packaging is made up of
recyclable materials, which
you can dispose on local recycling
points.
Never place power tools in
the domestic waste!
According to the European Directive
2012/19/CE
electronic equipment waste and its
transposition into national law, power
tools must be collected separately
and delivered to the collection sites
provided for this purpose.
You can obtain information regarding
the disposal of the compressor through
the person in charge for the recycling
in your city.
system.
7. CUSTOMER SERVICE
Phone: 00351 256 331 080
E-mail: sat@centrallobao.pt
Website: www.centrallobao.pt
the
on
electrical
and
Publicidad
