Publicidad
Mounting the Print Server
The print server is a so-called slot card that is simply inserted into the provided slot.
Prepare the printer
1. Turn the printer off.
2. Disconnect the printer's power cord.
3. Remove the screws from the interface cover.
4. Remove the metal cover.
Insert the print server
1. Insert the print server board into the slot until the board locks
2. Fasten the print server board screws.
Connect the print server
1. Connect the network cable (RJ-45) to the print server.
2. Connect the printer's power cord to the printer.
3. Turn the printer on.
4. Press the status button of the print server in order to print out
Hardware Installation Guide
Proceed as follows:
Proceed as follows:
into the receptacle.
Proceed as follows:
a status page.
13
Publicidad
