HQ-Power VDPLOW1212RGBWP Manual Del Usuario página 6

7.2 Menu
Access the menu using the control panel [6]. Select the menu or submenu with ENTER, select value with
UP or DOWN, confirm with ENTER. The menu is composed of following submenus:
menu
d001
A001
cF01
CC01
CS01
r.000
g.000
b.000
E.000
y.000
dEno
Soun
dEL0
7.3 Stand-Alone Mode
In stand-alone mode, the device runs one of the built-in programs: automatic or sound-activated.
Stand-Alone Mode with Built-in Program
To set the device to stand-alone mode:
1. Unplug any connection from the DMX input [5] of the device.
2.
Press MENU to open the menu.
3.
Select one of the built-in programmes.
7.4 Master/Slave Mode
The master/slave mode allows for connecting several devices to a single master device in a daisy chain.
All slave devices will then work synchronously with the master device. The first device in the daisy chain
functions as the master device.
To set the devices to master/slave mode:
1. Unplug any connection from the DMX input [1] of the master device (the first device in the chain).
2. Connect the DMX input of the first slave device to the DMX output [2] of the master device.
3.
Connect the DMX input of the subsequent slave devices to the DMX output of the previous slave
device.
4. Select a working mode on the master device.
5. Set the DMX start address of each slave device to 1 (see DMX Mode for details). All connected
devices will work in synchronization with the master device.
7.5 DMX Mode
This mode allows you to control the device by any universal DMX controller.
•
All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This digital start address is the channel number from which the device starts to "listen" to
the DMX controller. The same starting address can be used for a whole group of devices or an
individual address can be set for every device.
•
When all devices have the same address, all the units will "listen" to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices
simultaneously. If you set individual addresses, each device will "listen" to a separate channel
V. 02 – 17/10/2014
VDPLOW1212RGBWP
description
DMX address setting 5-channel mode
DMX address setting 9-channel mode
fade-in and out from slow to fast
sudden colour change from slow to fast
pre-set fixed colour
red intensity
green intensity
blue intensity
white intensity
UV intensity
auto run
sound control
dimmer function
6
value
001-511
001-511
00-99
00-99
00-99
000-255
000-255
000-255
000-255
000-255
dEL0: dimmer off
dEL1: fast
dEL2: middle
dEL3: slow
©Velleman nv