Metra 99-7352B Instrucciones De Instalación página 3

1. Attach the pocket assembly to the radio
housing using the (4) #8 x 1/2" Phillips
screws provided. (Figure A)
2. Attach the climate control to the radio
housing using (4) #8 x 1/2" Phillips
screws provided. (Figure B)
3. Attach the factory gauges to the radio
housing using (4) #8 x 1/2" Phillips
screws provided. (Figure B)
4. Attach the provided (2) panel clips to the
upper legs and the (2) factory clips to the
lower legs of the radio housing.
Continue to Kit Assembly
KIT PREPARATION
(Figure A)
(Figure B)
1. Secure the radio brackets to the pocket
with the (4) #8 x 3/8" Phillips screws
supplied. (Figure A)
2. Secure the radio to the bracket/pocket
assembly with the screws included with
the radio. (Figure A)
3. Locate the factory wiring harness
and antenna plug in the dash. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS.
4. Secure the assembly into the sub dash.
5. Reassemble dash in reverse order of
disassembly using the radio housing
instead of factory panel.
(Figure A)
REV. 2/7/2019 INST99-7352B
3