Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting to an Antenna or
Cable
Connect an antenna, cable, or cable box to watch
TV while referring to the following. The illustrations
may differ from the actual items and an RF cable is
optional.
CAUTION
• Make sure not to bend the copper wire of the RF
cable.
Copper wire
• Complete all connections between devices, and
then connect the power cord to the power outlet
to prevent damage to your TV.
NOTE
• To improve the picture quality in a poor signal
area, purchase a signal amplifier.
• Use a signal splitter to use 2 TVs or more.
• If the antenna is not installed properly, contact
your dealer for assistance.
• DTV Audio Supported Codec: MPEG, HE-AAC,
Dolby Digital, Dolby Digital Plus
Other Connections
Connect your TV to external devices. For the best
picture and audio quality, connect the external
device and the TV with the HDMI cable. Depending
upon the model, a cable may not be provided.
Remote Control
(Image shown may differ from your TV.)
The descriptions in this manual are based on
the buttons on the remote control. Please read
this manual carefully and use the TV correctly. To
install batteries, open the battery cover, replace
batteries (1.5 V AAA) matching the
to the label inside the compartment, and close
the battery cover. Failure to match the correct
polarities of the battery may cause the battery
to burst or leak, resulting in fire, personal injury,
or ambient pollution. To remove the batteries,
perform the installation actions in reverse.
This remote uses infrared light. When in use, it
should be pointed in the direction of the TV's
remote sensor.
10
• Do not mix old and new batteries, as this may
damage the remote control.
A
(POWER) Turns the TV on or off.
Toggles between Radio, TV, CATV, and DTV.
Activates your preferred subtitle in digital mode.
B
Number button Enters numbers.
(pressing repeatedly).
Accesses your favorite channel list.
and
ends
scheduler.
CAUTION
TV/
RAD
LIVE TV
REC
Sets the length of time until the TV to turns off.
Resizes an image.
Changes the input source.
Turns the TV on if it is off.
Accesses the saved channel list.
Alternates between the two last channels selected
Adjusts the volume level.
Displays the program event according to time
Mutes all sounds.
Scrolls through the saved channels.
Moves to the previous or next screen.
A
B
Publicidad
