Publicidad
Idiomas disponibles
Idiomas disponibles
Before you start
Assembly
Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
Loop handle version
Loop handle assembly
U-handle version
U-handle assembly
WARNING
Assemble loop handle (A) and bracket (C) to drive shaft assem-
bly.
Position handle in comfortable operating position and tighten
Bolts (B).
E: Arrow
Install the handle so that it does not hide any of the
safety decals.
1.
Loosen handle bar support bolts (A).
2.
Locate handle bar in a comfortable operating position and
tighten 4 bolts (M5×25).
Install the handle so that it does not hide any of the
safety decals.
3.
To eliminate loosening of throttle wire (B) fix it to shaft tube
(2 places) (C) and to right hand U-handle (1 place) with wire
fixing clips (D).
After assembly, adjust the play of wire end (E) on carburet-
tor (F) side to 1 mm - 2 mm.
G: Nuts
10
F: To engine
CAUTION
CAUTION
CAUTION
Publicidad
