Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting the fastening torque
(screwdriver mode " ")
1
012734
The fastening torque can be adjusted in 21 steps by
turning the adjusting ring so that its graduations are
aligned with the pointer on the tool body.
First, slide the action mode change lever to the position
of
symbol.
The fastening torque is minimum when the number 1 is
aligned with the pointer, and maximum when the marking
is aligned with the pointer. The clutch will slip at various
torque levels when set at the number 1 to 21. Before
actual operation, drive a trial screw into your material or a
piece of duplicate material to determine which torque
level is required for a particular application.
NOTE:
The adjusting ring does not lock when the pointer is
•
positioned only halfway between the graduations.
Empty signal for remaining battery capacity
(specific country)
Only for tools with the button and LED indicator
012714
Stop the tool and with the tool stopped press the button
on the switch panel and the remaining battery capacity
will be signaled on the panel.
The status displayed on the switch panel and the
remaining battery capacity is shown in the following
table.
1. Adjusting ring
2. Graduation
2
3. Arrow
3
1. Button
2. LED indicator
2
1
LED indicator status
012023
NOTE:
Before checking the remaining battery capacity, be
•
sure to stop the tool.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing side grip (auxiliary handle)
1
3
4
2
5
012696
Always use the side grip to ensure operating safety.
Insert the side grip so that the protrusions on the grip
base and steel band fit in between the grooves on the
tool barrel. Then tighten the grip by turning clockwise.
To change the angle of the side grip, loosen and remove
the grip, then turn and insert it again.
Installing or removing driver bit or drill bit
012697
7
Remaining battery capacity
About 50% or more
About 20% - 50%
About less than 20%
1. Groove
2. Protrusion
3. Steel band
4. Grip base
5. Side grip
1. Sleeve
1
Publicidad
