Publicidad
Idiomas disponibles
Idiomas disponibles
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
1
014112
To tilt the base, loosen the bolt on the back of the base
with the hex wrench. Move the base so that the bolt is
positioned in the center of the bevel slot in the base.
1
3
2
014123
Tilt the base until the desired bevel angle is obtained.
The V-notch of the gear housing indicates the bevel
angle by graduations. Then tighten the bolt firmly to
secure the base.
Front flush cuts
1
014113
Loosen the bolt on the back of the base with the hex
wrench and slide the base all the way back. Then
tighten the bolt to secure the base.
Cutouts
Cutouts can be made with either of two methods A or B.
1. Base
2
2. Hex wrench
3. Bolt
3
1. Bevel slot
2. Base
3. Bolt
6
4. Graduations
5
5. V-notch
6. Gear housing
4
1. Base
2
2. Hex wrench
3. Bolt
3
A) Boring a starting hole:
1
014114
For internal cutouts without a lead-in cut from an
•
edge, pre-drill a starting hole 12 mm (1/2") or more
in diameter. Insert the blade into this hole to start
your cut.
B) Plunge cutting:
014115
You need not bore a starting hole or make a lead-
•
in cut if you carefully do as follows.
1.
Tilt the tool up on the front edge of the base with
the blade point positioned just above the
workpiece surface.
2.
Apply pressure to the tool so that the front edge
of the base will not move when you switch on the
tool and gently lower the back end of the tool
slowly.
3.
As the blade pierces the workpiece, slowly lower
the base of the tool down onto the workpiece
surface.
4.
Complete the cut in the normal manner.
Finishing edges
014116
To trim edges or make dimensional adjustments, run the
blade lightly along the cut edges.
9
1. Starting hole
Publicidad
