EN
Switching modes
• When using SGX-CA500, the firmware version is required to be 20150501.02.43 or
higher.
• Pedaling monitor mode (Page 15)
Can be switched with SGX-CA500. Cannot be switched with cyclocomputers from
other manufacturers. When the mode is switched to pedaling mode, the LEDs on the
sensors light green for 10 seconds.
Current mode
Dual power meter
Single power meter
• Dual power meter mode (Page 19)
The mode can be switched on SGX-CA500 or by operating the right sensor push
switch. When using with another manufacturer's Cyclocomputer, switch using
method 1. When the mode is switched to powermeter mode, the LEDs light orange
for 10 seconds.
Current mode
Pedaling monitor
Single power meter
4
Method 1
(Right sensor push switch)
Cannot be switched
Cannot be switched
Method 1
(Right sensor push switch)
Cannot be switched
○
LED
Method 2
lighting
(SGX-CA500)
method
○
The LEDs light
green for 10
○
seconds
LED
Method 2
lighting
(SGX-CA500)
method
○
The LEDs light
orange for 10
○
seconds