Screen Research MMS2-T-IS Manual De Instalacion Y Uso página 16

Rolling screen installation and operation manual
Each programming procedure consists of several steps; at the end of each step, the operator has 60 seconds to start the next step; this system is devised to prevent the risk of performing operations other
than those desired. Therefore, if the motor does not perform the operation exactly as indicated in the instructions, wait 60 seconds, then exit programming, or cancel the procedure as indicated at specific
point, and start the procedure all over again.
ENGINE 1 – ENGINE 2
The motor's settings follow an overwriting logic: therefore, once the end stop positions have been memorised they cannot be cancelled, but only overwritten by following the above-mentioned procedure from
the start.
In order to cancel the procedure in course, simultaneously press ■ and ▼ at any time, until the motor has executed 6 movements.
Made by Adeo Screen Sp. Z o.o. (Poland) Specifications are subject to change without notice. E&OE
Please verify that you are working with the latest revision of this document before specifying your screen.
Doc: MMS2-T-IS Installation Manual rev2 | 16.12.2020
RATIO MEMORIZATION
ENGINE 1 – ENGINE 2
With the Master remote control and the ▲▼ ■ keys, bring both
screens approximately to the position that you intend to programme
(to check the exact size of the format required, we recommend that
you project some images of the relevant format), then proceed as
follows
Press and release the button PRG, the engine performs 2
movements.
Keep ▲ and ▼ keys simultaneously pressed until the motor
performs 2 movements
Note: at this stage, in order to perform precision adjustments both
the motors must be moved exclusively with the ▲▼ keys. The
remote control will operate in a stuttering mode. In order to perform
millimetric adjustments press the ▲ or ▼ key briefly. To perform
longer movements (but still in a stuttering mode) keep the ▲ or ▼
key pressed. Proceed in this manner to position the two canvases
exactly where you want to programme them.
Once the required position is reached, keep the ■ key pressed until
the motor has finished performing 3 movements.
Press a button (from 1 to 5) the button of the PILOT remote control
which you intend to associate to the format, until each motor has
finished performing 4 movements.
The required format is now memorized on the Pilot remote
control of your choice (1-5) and the programming
procedure is concluded.
MOVEMENT OF FORMAT
TO CANCEL THE PROGRAMMING IN COURSE
Before start the programmation choose the engine you want to program with the number button, 1 –
fabric motor, 2 – masking motor.
Do the sequency below for each engine.
ENGINE 1
ENGLISH
ENGINE 2
Page 16