Publicidad
Idiomas disponibles
Idiomas disponibles
installation of slimline ii tray
Note: If you have not fitted the Universal Load Bed Legs,
fit them according to the Universal Load Bed Leg Fitting
Instruction - Document LASS026.
If your Slimline II Tray is not already assembled,
assemble it as per the Slimline II Tray Universal Assembly
Instruction - Document RRSTUNI.
(
)
With your Rack in the upside down position ( Product Sticker should be upside down ) slide two M8 x 25
A
Hex Bolts supplied with the Universal Load Bed Legs into the end of each Slat as indicated by the arrows
using the machined Slots as shown.
(
)
Space the two Leg Assemblies evenly either side of Midpoint of the Track so that they are spaced 884 mm
B
apart - outside to outside as shown below. Loosely tighten the bolts securing the Legs to the Track.
TRBU001 / KRLBUNI1_REV_A01
You will need:
3
13 mm Flat or Socket Wrench
Measuring tape
Friend
Publicidad
