Publicidad
Idiomas disponibles
Idiomas disponibles
14. Maintain tools with care. Keep tools clean for better and safer performance. Follow instructions
for changing accessories. Inspect extension cords periodically and replace if damaged. Keep hand
les dry, clean, and free from oil and grease.
15. Switch off the machine and disconnect the cable before performing maintenance or changing
accessories.
16. Remove adjusting keys and wrenches. Always make sure that keys and adjusting wrenches are
removed from the tool before turning it on.
17. Avoid unintentional starting. Don't carry plugged-in tool with finger on switch. Be sure the tool
is switched off when plugging it in.
18. During outdoor work use extension cords intended for outdoor use.
19. Stay alert when operating the machine. Do not operate tool when you are tired.
20. Check damaged parts. Before further use of the tool, any part of the casing or other parts that
are damaged should be carefully checked to determine that they will operate properly and per
form their intended function. Check for alignment of moving parts, mounting, and any other con
ditions that may affect its operation. A part that is damaged should be properly repaired or
replaced by an authorized service centre unless otherwise indicated elsewhere in this
instruction manual. Defective switches should be replaced by an authorized service centre. Do
not use the tool if the switch does not turn it on and off.
21. Do not use power tools for applications other than those specified in the instructions (other
than that for which it was designed).
22. To ensure the designed operational integrity of power tools, do not remove installed covers or
screws.
23. Do not touch movable parts or accessories unless the power source has been disconnected.
24. Use your tool at lower input load than specified on the nameplate to increase working
efficiency and decrease wear out.
25. Do not wipe plastic parts with solvent. Solvents such as gasoline, thinner, benzene, alcohol,
ammonia and oil may damage and crack plastic parts. Do not wipe them with such solvents.
Wipe plastic parts with a soft cloth lightly dampened with soapy water.
26. Consult an authorized service agent in the event of power tool failure.
27. Use only original replacement parts.
28. This tool should only be disassembled for replacement of carbon brushes.
29. Hold the rotary hammer by the insulated surface of the handles as it is possible that hidden
electric wires or the device's own power cord may be struck during work with the machine.
Contact with an electric wire of a power network may cause electrocution.
PRECAUTIONS ON USING THE MACHINE
1.
Wear protective glasses to protect your eyes.
2.
Use dust masks.
3.
Use earplugs to keep your ears noise-free while working.
4.
Check for the proper adjustment of the handle.
5.
The tool becomes very hot during operation.
6.
Be sure to use the side handle.
7.
Safe operation depends on one's work posture.
8.
Before commencing work, the oil level and tightness of screws is to be checked.
9.
When working in an elevated location, pay attention to objects and persons below.
10. Before you start breaking or chipping a wall, floor or ceiling, thoroughly confirm that no items such as
an electric cable conduit or pipes are cached inside.
11. Wear protective shoes to protect your feet.
12. To avoid injury from accidental starting, always remove the plug from the electrical socket before
installing or removing a drill bit, saw blade, sandpaper, accessory or attachment.
Rev. 13.10.2016
13
Publicidad
