Publicidad
Idiomas disponibles
Idiomas disponibles
90546223 PC1800FL PC180FL
CHANGING THE LIGHT BEAM
The light beam can be concentrated or dispersed by turning the lens holder (4).
REPLACING THE BULB (FIGURE F)
WARNING:
replacing the bulb. Such preventative safety measures reduce the risk of personal injury.
CAUTION:
Flashlight Catalog Numbers
PC1800FL, PCL180FL
NOTE: Use only KPR 18V 0.3A Replacement Bulb.
To replace the bulb:
1. Unscrew the lens holder (4).
2. Remove the bulb holder (8) by turning slightly counterclockwise as shown in figure F.
3. Pull the bulb (7) out of the spring and insert a new bulb.
4. Reverse above steps to reinstall bulb holder and lens holder.
NOTE: Do not look directly into the light beam.
F
8
7
4
PROBLEM
• Light will not illuminate. • Battery not installed properly.
• Battery will not charge.
For assistance with your product, visit our website at www.portercable.com for a list of
service centers, or call the Porter-Cable Customer Care Center at (888) 848-5175.
1/6/09
10:22 AM
Page 10
Shock Hazard. Disconnect battery pack before
Burn hazard. Lens or bulb may be hot immediately after use.
Porter Cable Service Replacement Bulb
TROUBLESHOOTING
POSSIBLE CAUSE
• Battery not charged.
• Light bulb needs replacing.
• Battery not inserted into charger.
• Charger not plugged in.
10
Service Part Number Bulb
90534275
7
POSSIBLE SOLUTION
• Check battery
installation.
• Check battery
charging requirements.
• Replace bulb as
outlined in this manual.
• Insert battery into
charger until LED appears.
• Plug charger into a
working outlet. Refer to
"Important Charging
Notes" for more details.
8
Publicidad
