HQ-Power NUCLILED 3000 Manual Del Usuario página 4

Protect this device from shocks and abuse. Avoid brute force when operating the device.

Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people. Any damage that may occur will most probably be due to unprofessional use
of the device.

All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.

Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.

Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.

Mechanical wear and LEDs are not covered by warranty.

A qualified technician shall install and service this device.

Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room temperature.

This device is designed for professional use on stage, in discos, theatres, etc. The device shall only
be used indoors with an alternating current of 230 VAC, 50 Hz.

Lighting effects are not designed for permanent operation: regular operation breaks will prolong their
lives.

Use the original packaging if the device is to be transported.

Keep this manual for future reference.
4. Features
The NUCLILED 3000 is a super bright strobe fixture with a unique design. It incorporates 3 arrayed cells,
each containing 132 SMD 5050 LEDs that generate an intense white light. The unit can also be used as a
stage blinder for up to a minute at a time when connected with DMX. In stand-alone mode, the light can
respond to sound via the integrated microphone, or you can select built-in macros for unique effects with
chases and flashes between cells. The unit covers all your operating requirements: manual,
master/slave, sound control, and DMX control.

very powerful strobe effect with very low power consumption

indoor use, for all kind of applications

stand-alone, master/slave or DMX-controlled

DMX-controlled via 5 channels (intensity of section A, B and C; speed; duration)

units can be powered and linked from one source via the powerCON in- and output connectors, and
the 3- and 5-pin DMX XLR in- and output connectors
5. Overview
Refer to the illustrations on page 2 of this manual.
1 bracket adjustment knob
2 fuse
3 powerCON input and output
6. Installation
Choose a suitable mounting spot. Connect the power cord to the mains. Switch off and disconnect after
use.
Mounting the Device

Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.

The carrying construction must be able to support 10 times the weight of the device for 1 hour
without deforming.

The installation must always be secured with a secondary attachment e.g. a safety cable.
V. 01 – 21/08/2014
VDPL3000ST
4 DIP switches
5 microphone
6 DMX input and output
4 ©Velleman nv