Publicidad
SLIDING DOOR HARDWARE - BY PASS
1
1
PREPARE OPENING
1572-QR (BYP-75)
Hmax = Door Height + 2-3/8"
Hmin = Door Height + 1-7/8"
1606-QR (BYP-100)
Hmax = Door Height + 2-1/2"
Hmin = Door Height + 2-1/8"
2
MOUNT FRAME HARDWARE
• Center track in opening.
• IMPORTANT: Place hangers loose
into track before securing.
• Using track as template, mark
screw locations.
• Drill 3/32" pilot holes and
secure with (#8 x 5/8") screws. (F)
Note: If necessary, track may be
cut with a fine tooth saw.
3
MOUNT DOOR HARDWARE
• Place quick release top mount plates on
top of each door at the distance shown
from the outside edge.
• Using brackets as a template,
drill 3/32" diameter holes and secure
with (#8 x 1") screws. (I)
• Drill 20 mm diameter hole
approximately 1/4" deep
on outside edge of each
door as shown to mount pulls.
2-Door Width = 2 x Door Width - 1"
36"
(91,4 cm)
2" (5,1 cm)
#310302_C (0416)
Instructions
Opening Height
Hauteur Ouverture
Altura Abertura
9/16"
(1,4 cm)
Assembly
1572-QR (BYP-75):
1-1/2" - 1-7/8"
(3,8 cm - 4,8 cm)
1606-QR (BYP-100):
1-3/4" - 2"
(4,4 cm - 5,1 cm)
Door Height
Hauteur Porte
Altura Puerta
3/8" - 1/2"
(1 cm - 1,3 cm)
Publicidad
