Publicidad
Idiomas disponibles
Idiomas disponibles
Position the end louvers to the desired amount of discharge air flow.
Discharge air temperature can be controlled to some extent by opening or closing the louvers. When the
louvers are closed, the warmest localized discharge air is achieved. Fully opened louvers will throw the warm
discharge air to the back and front of the vehicle for more efficient circulation and faster warm-up. Although
the air temperature is lower with the louvers fully opened, the heating capacity is still the same.
If dirty filters or overly restricted louver position results in a cessation of electric heat, turn off power to the unit
at the mode selector switch. Wait ten minutes and restore power. The heater is equipped with a safety lock-out
switch. Correct the low air event to insure proper operation.
V.
For Air Circulation Only (Refer to Figure 1, page 3).
A.
Turn the selector switch to "LOW FAN" or for maximum air flow, to "HIGH FAN".
B.
Position the louvers to the desired direction the discharge air is to flow.
I.
Owner
One of the biggest advantages to your new Coleman-Mach air conditioner is that the maintenance needed to
keep the unit in good care is minimal. In fact about the only thing you, the owner, must take care of is the
cleaning and replacement of the filters.
Filters are made from long life non-allergenic natural fibers or foam which can be cleaned and reused, and
which completely filter the circulated air when the air conditioner is in operation. If the filters are not cleaned
at regular intervals, they may become partially clogged with lint, dirt, grease, etc. A clogged filter will produce
a loss of air volume and may eventually cause an icing-up of the cooling (evaporator coil).
Do not operate your air conditioner for extended periods of time without the filter installed.
An even more serious condition occurs when the air conditioner is operated without a filter.
When this happens the lint, grease, etc. that are normally stopped by the filter are now
accumulating in the cooling coil. This not only leads to a loss of air volume and a possible
icing-up of the cooling coil, but could also result in serious damage to the operating
components of the air conditioner.
We recommend that the filters be cleaned or changed at least every two weeks when the air
conditioner is in operation.
When the selector switch is in the "LOW FAN" or
"HIGH FAN" position, the blower motor will
operate continuously.
V. ROUTINE MAINTENANCE
IMPORTANT
NOTE
-5-
Publicidad
