Ruijie RG-EW300R Manual Del Usuario página 6

Scenario 2: Connect the Device to the Primary Router (WPS)
1.
The device is
starting up
after power-on.
The system status LED
is blinking blue.
Please wait for 1 to 2 minutes.
Power supply faceplate
Place the Wi-Fi extender close to the primary router.
Operating Status
Factory status
The device
accesses
the network
successfully.
The device fails to
connect to the
primary router.
2.
Startup is
complete.
The system status
LED is solid blue.
Primary router
LED Status
The system status LED ❹
is solid blue. The signal
status LED ❸ is off.
The system status LED ❹ is
solid blue. The signal status
LED ❸ is solid white.The
more signal bars in solid
white indicates the stronger
signal.
The system status LED ❹
is solid red. The signal
status LED ❸ is off.
3.
Press the WPS button
on the primary router.
4.
Press the WPS button on the
Wi-Fi extender in 2 minutes.
The system status LED is solid
blue.Three signal bars are
blinking alternately.
If the device is still in the factory
status after the configuration of the
Wi-Fi extender is complete, it indi-
cates that the device is not properly
installed. Please place the Wi-Fi
extender closer to the primary
router and try again as instructed in
the figure.
The network is reachable. The
Wi-Fi extender and the primary
router broadcast the same Wi-Fi
signal.
Please place the Wi-Fi
closer to the primary router.
4
Description
extender