Zodiac Vortex Manual De Instalacion Y Uso página 14

2.6.2 Programming cleaning cycles
Program up to 7 cleaning cycles (for example, 2 days per week: Wednesdays and Saturdays over 4 weeks).
• You must set the time before you program the cleaning cycles, see § « 2.6.1 Setting the time ».
• Start by selecting the cleaning cycle on the control box, see § « 2.5.1 Cleaning mode selection (depending on model) ».
• Then program the days, hours and minutes.
DAY
Press for 3 seconds on
The days of the week flash twice.
LED and the current
The
date and time flash to remind
you.
Press
to start programming
Select the day with
or
Press to confirm,
• The programming stops automatically at the end of the 7th cleaning cycle and the LED
• To cancel ALL the programming, exit the menu
Tip: check the programming
Press . Each programming is displayed for 3 seconds.
13
HOURS
The hours start to flash
Select the hour with
or
Press to confirm,
To cancel a day's programming,
until the display
hold down
changes.
and hold down
MINUTES
The minutes start to flash
Select the minutes with
or
(every 1/4 hour)
Press to confirm,
Exit the menu by pressing
or
switches off.
until the display changes.