Donner B1 Manual Del Usuario página 4

PANEL INTRODUCTION
MAIN OUT: 1/4" TS mono output connector that outputs overall signal and is controlled by Master
1
knob.
MIDI IN: MIDI input connector that inputs MIDI messages and can support the use of external
2
MIDI devices.
MIDI OUT: MIDI output connector that allows you to output the MIDI signal from this unit to control
3
other MIDI devices.
USB-C : Type-C connector that connects to the host computer for firmware updates and USB MIDI
4
data transmission.
POWER INPUT: DC9V power input
5
POWER SWITCH: Power on/off.
6
AUX IN connector: 1/8" TS audio signal connector that used for connecting other audio signals and
1
outputting mixed signal with the sound of B1 through MAIN OUT jack and PHONES jack.
Headphone output interface: 1/8" audio signal interface that used for connecting the headphones
2
output. Turn Master knob can control the volume.
3 Sync In interface: connecting an external clock to start or stop signal.
4 Sync Out interface: connect and send internal clock to external device.
5 Wave switch : shifting between saw wave and square wave on the currently used oscillator.
Pitch knob: potentiometer with a detent at the center that controls oscillator frequency, with a range
6
of fifth intervals lower on the left half and fifth intervals higher on the right half.
7
Cutoff knob: controlling the cutoff frequency of low-pass VCF filter, the larger the value of the knob
the higher the cutoff frequency.
Resonance knob: controlling the signal amplitude at the cutoff frequency point, the larger the knob
8
value the stronger the gain.
6 5 4
02
3 2 1