Donner B1 Manual Del Usuario página 9

1.
Press the RATCHET button, the RATCHET button indicator flashes and the display
shows the current ratchet value.
2.
Short press ▲ or ▼ to adjust the ratchet value. The ratchet value can be adjusted
from 1 to 4. If pressing and holding ▲ or ▼, the ratchet value will be adjusted rapidly
Set ratchet
in succession.
(repeats)
3. Press the RATCHET button to exit ratchet setting mode.
Note.
Ratchet is individually adjustable for each step
The ratchet effect is more pronounced when the gate length value is small (but > 0).
When slide enable or gate length is 8 (tie), ratchet does not work.
Note:
By default (when not editing step parameters or Octave), press ▲ or ▼ can switch to previous/next step.
SAVING PATTERN
If the pattern saving operation is not performed, any changes to the pattern may be
discarded. Please refer to the following steps to save the edited pattern if necessary.
Press the SAVE button once to enter the save mode, the PATTERN button indicator and SAVE
button indicator will flash and the display will show the current pattern position.
To save to the current position, please press the SAVE button once again. The PATTERN button
indicator, the SAVE button indicator and the display flash rapidly several times at the same time to
indicate a successful saving.
To save to another location, please press ▲ or ▼ to select a new pattern location (1 - 128), then
follow step 2 to confirm the saving.
Note:
* Failure to operate after a timeout will automatically exit save mode and discard saving.
* Pressing and holding the SAVE button for about 2 seconds can exit the save mode and discard saving.
IMPORTING PATTERN
The last pattern used is imported by default for each time the device is turned on, or you can select
another pattern to play by following the steps below. There are 128 patterns to choose from.
When the PATTERN button indicator is on or flashing slowly, it indicates that it is currently in pattern
selection mode, otherwise press the PATTERN button once to enter pattern selection mode and the
display shows the current pattern value.
Press ▲ or ▼ to adjust the pattern value, the pattern value range is from 1 to 128. If pressing and
holding ▲ or ▲, the pattern value will be adjusted rapidly in succession.
After selecting the desired pattern, release ▲ and ▼, and the device will automatically import the
selected pattern.
Note:
* Press and hold the PATTERN button for about two seconds to quickly re-import the current PATTERN.
* a. If the current pattern is playing, the default is to wait for the current pattern to finish playing before
playing the new imported pattern.
b. If you need to play the newly imported pattern immediately, please change the pattern waiting setting
in the APP.
07