MoMi BELOVE Manual De Instrucciones página 6

• To prevent injury to the child from falling, the bed should no longer be used if the child can climb up
and out of the product.
• All assembly elements and hardware must be properly tightened during assembly, regularly chec-
ked and, if necessary, tightened.
• Be aware of the risk of open fire and other sources of strong heat, such as electric bar fires, gas fires
etc. In the near vicinity of the cot.
• Do not use more than one mattress in the cot. Only use the mattress sold with this cot, do not insert
a second mattress, there is a risk of suffocation.
• If you leave your child unattended in bed, always check that the side entrance is closed with a
zipper.
• Do not use the product if any of its components is damaged, torn or missing, use only those appro-
ved by the manufacturer.
• Do not leave anything in the bed or place the bed near other equipment that could support the
child's foot or cause the risk of suffocation or hanging the child, e.g. wires, cords of curtains / blinds.
• Do not use the product without a mattress.
PRODUCT ASSEMBLY:
1. Take the travel baby bed out of the bag and loosen the velcro straps. Place the bed on the floor and
put the bag aside.
2. Remove mattress pad.
3. Separate the legs pulling them apart. Keep the central lock up. Otherwise handrails will not flt in the
right place.
Note! The baby rails will not lock when the floor is unfolded.
4. Pull the middle part of each top rail covered with materi¬al so that they flt into place. Start with the
longer rails, and then the shorter one.
5. Push the middle lock until the surface is completely flat.
6. Place the mattress in the baby bed.
7. The travel cot is now ready to use.
FOLDING:
1. Remove all the bed accessories. Remove the mattress, cano¬py, organizer and all the other
accessories. Grasp the centre handle located in the middle of the floor and pull it
2. To unlock the upper rails, press the indicated buttons on each side of them. Pull it slightly up and
then push it down. Unlock the shorter sides first, and then do the same with the longer ones
3. While still pulling up the handle, lift the floor of the baby bed and fold the legs.
4. Gather unite together.
5. Wrap the folded bed with the mattress and fasten it with Velcro straps.
6. Put the folded baby bed into the bag.
7. The travel cot is now ready for easy carrying or storage.
PRODUCT MAINTENANCE:
The frame of the bed can be wiped with a damp cloth. Clean the upholstery with a soft brush.
Thank you for reading the manual. Please keep it for future reference.
6
EN