grasped by a child.
• Do not add any extra cords or straps to secure the product to the crib.
• Entanglement in the cords may cause suffocation!
• Keep out of the reach of children.
• Do not use elements and accessories or other spare parts than those recommended by the manufacturer.
• Contact us immediately via our website if any part of the product is damaged or if any part is missing. In such
cases, stop using the product immediately.
• During folding, the child must be far from the place where the folding / unfolding operation is performed.
• Each time check if all the elements fit together as instructed in the instruction.
• Do not attempt to modify or repair the product yourself. Only qualified service personnel are authorized to
do so.
• Inspect the product for mechanical damage such as tears in materials or missing and cracked parts. If any
element is in doubt, discontinue use of the product immediately
• Attach this toy out of the reach of the child. To prevent possible injury from entanglement, remove play when
baby tries to pull up and crawl.
PRODUCT COMPONENTS:
1. Mattress
2. Removable handrail
3. Gondola for sleeping
4. Handle for height adjustment
5. Front supporting tube
6. Back supporting tube
7. Brackets
8. Cross supporting tube
9. Legs
10. Wheels
11. Belts
ASSEMBLY THE COT:
1. MOUNTING THE BRACKETS
Insert the transverse support tube into the plastic connector of the leg until you hear a click (fig. 1). Repeat
the same operation with the other leg. Then insert the bracket into the upper hole of the leg until you hear a click,
repeat the same operation with the other leg and the bracket (fig. 2).
2. GONDOLA FOR SLEEPING
Insert the front and rear metal support tubes into the designated holes until you hear a "click" (fig. 3).
Put the securing strap, which is located on the bottom edge, through the rectangular hole in the connecting
brackets (fig. 4) from the top. Next, pull the strap through the metal half-circle located under the cot and tighten
it firmly (fig. 5). Repeat on the other side of the cot.
Put the mattress on the bottom of the cot (fig. 6)
DANGER: remember to always fully lift the textile sides of the crib and close the zippers when the crib is not
attached to an adult's bed.
NOTE: When adjusting the height, make sure that the angle of the cradle base from end to end (head to toe)
is no more than 10 degrees.
EN
7
11