Generating Pressure - WIKA CPP700-H Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

5. Commissioning, operation
2. Mount the test item at the end of the test item hose
G 1/4 female thread as a standard
3. Tighten adapters, if used, to a maximum torque of 15 Nm.
EN
A stainless steel set of adapters is available as accessories. The set
contains a set of high-quality nylon sealings or O-rings.
Dirty or chemically contaminated test items should not be fitted as they
contaminate the system unless they are first cleaned.
Alternative mounting of the test item
1. Remove the test item hose
2. Select an adapter suitable for the desired test item (optional set of adapters available
on request).
3. Mount the adapter on the hand test pump (G 1/4 female thread).
4. Mount the test item on the adapter.
This makes it possible to substantially reduce volume and to facilitate the test
pressure generation.

5.7 Generating pressure

6
5
Pump handles
5
Toggle control, system and high-pressure generation
6
1. Before generating pressure, press the toggle control
The pump handles
2. Open the pressure relief valve
14
from the pump by turning it.
1
Handles for initial pressure
generation
are positioned apart ("initial pressure generation" position).
5
2
WIKA operating instructions, models CPP700-H and CPP1000-H
1
Handles for high-pressure
6
5
6
.
.
generation
, if necessary.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cpp1000-h

Tabla de contenido