ION Block Rocker XL Guia Del Usuario página 9

Troubleshooting
If the unit is not charging, make sure the power cable is properly connected to the power
input and the power outlet.
If the sound is distorted, try lowering the volume control of your sound source, musical
instrument, or microphone. Also, try to reduce the overall volume of Block Rocker
the Volume knob.
If there is too much bass, try adjusting the tone or EQ control on your sound source to lower
the bass level. This will allow you to play the music louder before clipping (distortion) occurs.
If there is a high-pitched whistling noise when using microphones, this is probably
feedback. Point the microphone away from the speaker.
If you can't hear the microphone over the music volume, turn down the music volume from
your source.
If you can't play music from a flash drive, the USB port is only for charging USB devices.
If you cannot connect your audio device to Block Rocker
•
Have your audio device (e.g., smartphone or tablet) and Block Rocker
together as possible while trying to connect. Make sure both the audio device and Block
®
Rocker XL are unobstructed by walls, furniture, etc.
•
Reset the Bluetooth
from any other audio device and restart the search process. If this does not work right
away, power off Block Rocker
®
Bluetooth Device
•
Reset the Bluetooth
on. You can find this under the Bluetooth
audio device.
If this does not work, and you have connected to Block Rocker
®
Rocker XL in the list of available or previously connected devices in your audio device's
®
Bluetooth menu, tap the "gear" or "i" icon located next to it and then select Unpair or
Forget. Turn Block Rocker
your available devices list.
Note: If Block Rocker
within range, you may need to repeat this process with that audio device to fully
disconnect.
If you experience audio dropouts while playing music from a Bluetooth
be happening because your unit is trying to link to another speaker. This can occur if you
power off a speaker that was linked to your unit or if you have just turned on your unit and it is
in Stereo-Link mode. To stop the audio dropouts, exit Stereo-Link mode by double-pressing
the Link button. Alternatively, you can wait for your unit to link to another Block Rocker
speaker if there is one within range.
If you would like to stop your speaker from automatically linking when you power it on,
make sure you double-press the Link button to exit Stereo-Link mode before you power it off.
®
connection on Block Rocker
®
XL and then power it back on. See
for more information.
®
connection on your audio device by turning Bluetooth
®
XL off and back on and try pairing again once it reappears in
®
XL has been paired to another audio device recently that is still
®
XL via Bluetooth
®
XL to disconnect Block Rocker
®
menu in the Settings for your phone or other
®
XL using
®
:
®
XL as close
Pairing with a
®
off and back
®
XL before, find Block
®
device, this may
®
XL
®
XL
9