Cleco NeoTek 937731PT Instrucciones De Montaje página 9

1 Product description
As an accessory for NeoTek tools, the 2D Reader allows the scanning of barcodes.
2 Use
2D Reader
Requirements
NeoTek tool
Software requirements
Note
Note the order of the software updates:
1. Perform controller software update.
2. Perform measurement card firmware update.
3. Perform TIM firmware update.
4. Perform firmware update for accessories.
3 Installation
Note
Before installing, take the tool out of operation or switch off the controller.
30/50/70ESN(...), 30/50/70EAN(...)
• First accessory: see Figure 01, Page 3
• Second accessory (optional): see Figure 02, Page 3
30/50EPN(...)
• First accessory: see Figure 03, Page 4
• Pistol suspension bail (optional): see Figure 04, Page 4
4 Activating accessories
To activate accessories via the controller:
 Select Navigator > Communications > Part ID > Part ID Source > Tool Scanner.
For additional settings, see the particular software documentation for the controller.
Apex Tool Group
937731PT
Order No.
30 Series...,
50EAN30-
FA3
Angle head,
inline
P2399MA | 2019-06
942391PT 942394PT
50 Series... 70 Series...
except
50EAN30-
FA3
Angle head, Angle head,
inline inline
2D reader: S169352-101 or later
Bootloader: S169353-101 or later
Controller: e.g., S168813-1.8.1 or later
Measurement card: S168025-507 or later
TIM (Tool Interface Module): 3.4
T55- T55-
3000018 3000019
30 Series... 50 Series...
Pistol Pistol
1
EN
9