Publicidad
Idiomas disponibles
Idiomas disponibles
Engine Preparation
• Save all instructions
A
Engine Oil
CAUTION
Engine shipped without oil. Failure to add oil will result in
serious engine damage.
A bottle of SAE 30 engine oil is included with your edger.
Refer to the chart on the right for alternative oil types to
use at different temperatures. Always use a high quality
detergent oil classified "For Service, SG, SH, SJ" or higher.
Do not use special additives.
CAUTION
Always use recommended oil type. Using dirty oil or
incorrect oil type such as 2-stroke engine oil will shorten
engine life.
NOTE: Engine Oil Capacity is 355 ml. For the first time fill,
simply add the entire contents of the provided oil bottle to
the crankcase.
HOW TO CHECK OIL LEVEL AND FILL TO PROPER LEVEL
WARNING
Before checking oil, make sure engine is off, and spark
plug wire has been disconnected from spark plug.
1. Place the edger on a level surface and make sure the
adjustable wheel heights are set so the main frame of the
edger is level. (See Figure 3)
2. Remove the oil fill cap/dipstick and wipe clean with cloth.
(See Figure 3)
3. Insert dipstick into fill spout but do NOT screw in.
Remove dipstick and check oil level.
4. When oil level is full, the oil will be at upper limit on dip
stick. If oil level is near or below the lower limit, oil must
be added. (See Figure 4)
5. Add oil slowly until the oil level reaches the upper limit of
the dipstick. Use a funnel or nozzle to reduce spillage.
CAUTION
Frequently check oil level while filling. DO NOT
OVERFILL. DO NOT UNDERFILL. Running engine at
improper oil level will seriously damage engine.
6. Replace and tighten dipstick.
7. Clean up any spilled oil.
Questions? Call Toll Free at 1-800-737-2112
SAE
TEMP
-20
20
0
-30
-20
-10
Ambient Service Temperature
Adjustable Wheels
Upper Limit
Lower Limit
7
Copyright © 2011 MAT Engine Technologies, LLC
SAE 10W-30
SAE 30
60
80
100° F
40
0
10
20
30
Fuel Tank Cap
Oil Fill Cap/Dipstick
Figure 3
Oil Fill Cap/
Dipstick
Figure 4
40° C
Publicidad
