Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY STEP 2
For Sectional and One-Piece Doors Only
Install the Trolley
• Attach the trolley threaded shaft to the trolley with
the lock washer and nuts as shown.
• As a temporary stop, insert a screwdriver into the
hole in the front end of the rail.
• Slide the trolley assembly along the rail to the
screwdriver stop.
NOTE: If trolley hits against any nuts on the rail,
the bolts and nuts were attached from the wrong
side and must be repositioned. Review Assembly
Step 1.
ASSEMBLY STEP 2
For Sliding and Swinging Gates Only
Install the Trolley
• Attach the trolley threaded shaft to the trolley with
the lock washer and nuts as shown.
• Insert a hex bolt into the hole in the front end of
the rail.
• Slide the trolley assembly along the rail until it
rests against the hex bolt (trolley stop).
NOTE: If trolley hits against any nuts on the rail,
the bolts and nuts were attached from the wrong
side and must be repositioned. Review Assembly
Step 1.
Temporary Stop
Screwdriver
Hex Bolt
5/16"-18x7/8"
Hex Bolt
Trolley Stop
Lock Washer
5/16"
Nut
5/16"-18
Lock Washer
5/16"
Outer Nut
5/16"
Trolley
HARDWARE SHOWN ACTUAL SIZE
Hex Bolt
5/16"-18x7/8"
Inner Nut
5/16"
Outer Nut
5/16"
11
HARDWARE SHOWN ACTUAL SIZE
Lock Washer
Nut
5/16"
5/16" -18
Inner Nut
5/16"
Trolley
Threaded
Shaft
Nut
5/16"
Trolley
Threaded
Shaft
Lock Washer
5/16"
Cable Pulley
Bracket
Lockwasher
5/16"-18
Publicidad
