Velleman LABPS3005D Manual Del Usuario página 4

4. Features

dual LED display for voltage and current

coarse and fine adjustments of voltage and current

protection mode: voltage or current limiting

output connectors: insulated safety plugs

organic glass front panel / other panels made of steel

memory: 5 programmable memories

computer connectivity: pc remote control via USB or RS232

software V2.5 included for Windows XP, Vista and W7, W8, W8.1 (32 bits + 64 bits)
5. Description
The LABPS3005D is a highly accurate, DC-regulated power supply with an adjustable output. This output
can be used for constant voltage (C.V.) and constant current (C.C.).
The output voltage can be adjusted between 0V and 30V when the device is in the constant voltage
mode. The current-limiting point can be set arbitrarily in this mode.
The output current can be adjusted continuously between 0A and 5A in the constant current mode.
The output current and voltage are indicated on the LED displays.
Refer to the illustrations on page 2 of this manual.
1 Off/On: output on/off
2 OVP: overvoltage protection on/off
3 OCP/Beep: overcurrent protection / key
tones on/off
4 Lock/Unlock: lock/unlock panel keys
5 M1-M4: memory save / recall
6 Current display (ampere)
7 Voltage display (volt)
8 OVP indicator: overvoltage protection is
active
9 OCP indicator: overcurrent protection is
active
10 CC indicator: constant current mode
11 CV indicator: constant voltage mode
12 OUT indicator: output is on
6. Operation
Switching the Power Supply On or Off
1. Connect the included power cord to the back of the device [23] and plug the other end into a
suitable, earthed power socket.
Always connect the device to an earthed power socket.
2. Press the Power button [19] to switch the power supply on.
The power supply automatically recalls the settings from memory 1. (See Setting Voltage and
Current for more information.) The display shows the existing settings, the M1 indicator [13]
lights.
At this moment, there is no output voltage or current on the output terminals.
3. Press the Power button [19] to switch the power supply off.
V. 05 – 27/05/2015
LABPS3005D
13 M1-M5 indicator: active memory
14 Adjust: adjustment knob for voltage and
current; selection of memory 5
15 < >: digit selection buttons for coarse/fine
tuning of voltage and current
Voltage/Current: select between voltage
16
or current for adjustment
17 Earth (ground) terminal, connected to the
chassis and earth pin of the power supply
socket
18 Output terminals
19 Power: on/off button
20 RS232 port for remote control via pc
21 USB port (type B) for remote control via pc
22 Fan
23 Power supply socket
24 Fuse holder
4 ©Velleman nv