Descargar Imprimir esta página
Glacier bay PPSOFGOK24 Guía De Uso Y Cuidado
Glacier bay PPSOFGOK24 Guía De Uso Y Cuidado

Glacier bay PPSOFGOK24 Guía De Uso Y Cuidado

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

TOOLS REQUIRED
Hammer
Safety goggles
Measuring tape
Wall hardware
Installation
1
PREPARING FOR INSTALLATION
NOTE: Before installation, make sure all parts are present.
Compare parts with the Hardware Included list. If any part is
missing or damaged, do not attempt to install the product.
□ Determine the desired mounting location, and mark the
wall where the unit will be installed.
NOTE: For secure installation, the unit must be mounted
to at least one wall stud.
3
INSTALLING THE CABINET
□ For wall stud installation, insert #12 x 3 in. screws with
washers into the stud locations (not included).
□ For drywall installation, drill holes at the appropriate
locations and insert toggle bolts with washers (not included).
□ For concrete wall installation, drill 1/4 in. holes at the
appropriate locations and insert #12 wall anchors, followed
by #12 x 3 in. screws (not included).
4
INSTALLING THE VANITY TOP
IMPORTANT: Do not use plumber's putty.
NOTE: The faucet, drain, and supply lines are not included. Install these
parts to the vanity top according to the manufacturer's instructions.
□ Apply silicone caulk/sealant (not included) to all
four corners of the cabinet.
□ Place the vanity top onto the cabinet.
□ Position the top so that it has an equal amount of
overhang on each side and use a level to ensure
the vanity top surface is level.
□ Apply silicone onto the seam between the edge
of the vanity top and the wall, smooth the bead,
and allow to cure before use.
Model# PPSOFGOK24, PPSOFGOK30, PPSOFSVL24, PPSOFSVL30
Phillips screwdriver
Power drill
Caulk/sealant
Item# 1000 398 630, 1000 398 637
1000 050 591, 1000 398 605
1000 398 610, 1000 398 616
PPSOFWHT24, PPSOFWHT30, PPSOFTRF24
Use and Care Guide
HARDWARE INCLUDED
AA - Knob x 2
Level
2
POSITIONING THE CABINET
□ Move the cabinet into place,
and use wood shims to level the
cabinet against the wall.
5
INSTALLING THE HARDWARE
□ Attach the knob (AA) to the cabinet
with the provided screw (BB).
1000 050 588
Vanity Combo
BB - Knob screw x 2
HOMEDEPOT.COM
Please contact 1-888-774-8062 for further assistance.
BB
AA

Publicidad

loading

Resumen de contenidos para Glacier bay PPSOFGOK24

  • Página 1 Item# 1000 398 630, 1000 398 637 1000 050 591, 1000 398 605 1000 398 610, 1000 398 616 1000 050 588 Model# PPSOFGOK24, PPSOFGOK30, PPSOFSVL24, PPSOFSVL30 PPSOFWHT24, PPSOFWHT30, PPSOFTRF24 Use and Care Guide Vanity Combo TOOLS REQUIRED HARDWARE INCLUDED...
  • Página 2 Troubleshooting Problem Possible Cause Solution The doors do not align or The hinges are misaligned. Hold the door while loosening Up — Down the space is too big or too screws. Align the doors properly, In — Out tight between the doors. and re-tighten the screws.
  • Página 3 1000 398 630, 1000 398 637 1000 050 591, 1000 398 605 1000 398 610, 1000 398 616 1000 050 588 Núm. de modelo PPSOFGOK24, PPSOFGOK30, PPSOFSVL24, PPSOFSVL30 PPSOFWHT24, PPSOFWHT30, PPSOFTRF24 Guía de uso y cuidado Combo de tocador HERRAMIENTAS REQUERIDAS...
  • Página 4 Resolución de fallas Problema Posible causa Solución Arriba — Abajo Las puertas no se alinean Las bisagras están Sostenga la puerta mientras o el espacio es demasiado desalineadas. afloja los tornillos. Alinee las grande o está demasiado puertas adecuadamente y Izquierda —...

Este manual también es adecuado para:

Ppsofgok30Ppsofsvl24Ppsofsvl30Ppsofwht24Ppsofwht30Ppsoftrf24 ... Mostrar todo