Publicidad
Idiomas disponibles
Idiomas disponibles
5. Move the tool slowly and evenly forward, following the
cut line.
Angled Cuts (Fig. A, F)
1. Using a marker or grease pencil, mark the area to be cut.
2. Release the bevel adjustment knob
desired angle.
3. After selecting the desired angle, tighten the bevel
adjustment knob to secure the shoe.
4. Align the internal part of the cutting guide
line on the workpiece.
5. Turn the tool on and wait for the blade to reach its
maximum velocity.
6. Move the tool slowly and evenly forward, following the
cut line.
MAINTENANCE
Your D
WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
WARNING: This is a non user maintenance tool. It has
to be maintained by an official D
dealer only.
Lubrication
WARNING: NEVER spray or in
any other way apply
lubricants or cleaning
solvents inside the tool. This
may result in personal injury
and can seriously affect the
life and performance of the tool.
D
WALT tools are properly lubricated at the factory and are
e
ready for use. However, it is recommended that, once a year,
you take or send the tool to a certified service center for a
thorough cleaning and inspection.
17
and move it to the
16
with the cut
WALT maintainance
e
Cleaning
WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Optional Accessories
WARNING: Since accessories, other than those offered
by D
WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
EngLIsh
WALT recommended
e
25
Publicidad
