Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
CONTROL PANEL
DISPLAY
NOTE: Below functions are
notifications only.
Anion Function
Anion function starts after the power is turned on, and the icon is lit. It will
constantly run. Anion function creates negative ions which attaches to dust,
allergens, odors and removes them from the air.
Clean Filter
When the icon slowly flashes, the filters need to be cleaned. All filters can be
cleaned except the HEPA Filter. Press the air volume adjustment button for 4
seconds to reset and return to normal operation.
Sleep Mode
Sleep mode will activate in AUTO Mode depending on light sensitivity in the
room. Sleep mode will not work when in manual mode. When the lights become
dimmed, the fan runs on low speed with low noise.
Check Filter/Filter Cover
Icon will light up and blink red when the filter is not installed correctly or the
cover to the unit is not secured. Once issue is corrected the icon will shut off.
Ultraviolet Light
Eliminates viruses, bacteria, mold and mildew.
TVOC/PM2.5 Air Quality Indicator
Indicator lights which will change color according to the air quality detected by
the sensor. PM2.5 are particles that have a diameter less than 2.5 micrometers.
Examples would be dust, spores and pollen.
TVOC (Total Volatile Organic Compounds) are a group of VOCs used to repre-
sent an entire group of pollutants, i.e. paint, varnishes, air fresheners, cleaning
products, gasoline, cooking odors, etc.
TVOC/Air Quality Indicator Lights
Number
1-50
51-100
101-150
151-500
HEPA Filter Replacement
After 2,160 hours of use, REPLACE FILTER indicator light will flash when the
HEPA/Activated Carbon filter needs to be replaced. Once replaced, press the air
volume control button
WARNING: Do not run the unit without the filters in place.
UV
Color of light
Blue
Green
Yellow
Red
for 5 seconds to reset.
Air quality
Excellent
Good
Normal
Poor
Page 9
Publicidad
