Publicidad
Idiomas disponibles
Idiomas disponibles
Power
Terminal Block Installation
NOTE: Ensure all power is off/disconnected before beginning!
1 Loosen appropriate screws. Insert bare power-supply wires into appropriate terminals (positive wire into
positive [V1+] terminal, negative wire into negative [V1-] terminal, ground wire to ground [GND] terminal).
2 Tighten appropriate screws to secure wires. Repeat these steps for
a second power supply if desired (V2+, V2-, GND).
3 Install block into the device.
Front panel
LEDs
DIP Switch — LFPT/100M
LED
Color
P1/P2
Green
FX
Green
1000M
Yellow
L/A
Green
Switch
Position
Link Fault Pass Through enabled: Devices on
a link must acknowledge that they are online
ON
before data can be transmitted. When one of the
LFPT
devices doesn't respond, data cannot be sent.
OFF
Link Fault Pass Through disabled
Copper interface management — restricts
ON
data transfer rate to 100Mbps
100M
OFF
No data transfer rate restriction
Status
Description
On
Power channel is powered.
Off
Power channel is not powered.
On
Fiber port is connected.
Off
Fiber port is not connected.
Flashing
Sending or receiving data.
On
1000 Mbps speed
Off
10/100 Mbps speed
On
Valid port connection.
Off
Connection not established.
Flashing
Sending or receiving data.
Description
Instructions
English
3
Publicidad
