Publicidad
3. Add water to the water tank (E) using a measuring cup / glass and do not exceed the maximum water level equal to a volume of 100
ml. Only tap water or purified water is suitable for this product. Do not add water during use when the device is running. (Fig.3) Only add
cold or lukewarm water. Pour the aroma oil into the water tank. The recommended dose is 0.10-0.15 ml per 100 ml of water. Essential oil
can cause discoloration. If it accidentally spills, wipe it off quickly with a cloth.
NOTE: Do not block the spray nozzle to avoid damaging the product.
4. Replace the top cover (B) vertically to keep the diffuser tight. (Fig.4)
Note: The top cover (B) should be closed before use.
5. Connect the plug of the AC adapter to the power socket, the device is now in standby mode.
SPRAY ADJUSTMENT: button G1.
- Press the spray button (right button) "MIST" once: the device sprays the mist continuously until the device switches off automatically
due to the consumption of water previously poured in.
- Press the spray button (right button) "MIST" again: the device will switch to intermittent mode. It will alternately generate mist for 30
seconds and stop producing mist for another 30 seconds. The cycles will repeat until the water in the tank runs out, then the device will
turn off automatically.
- Press the spray button (right button) "MIST" a third time: the device stops generating mist. (Fig.5)
LIGHT ADJUSTMENT: button G2.
- Press the backlight button (left button) "LIGHT" once: you will turn on the warm light in bright mode,
- Press the backlight button (left button) "LIGHT" again: you will turn on the warm light in dimmer mode.
- Press the backlight button (left button) "LIGHT" a third time: the light will be turned off. (Fig.6)
6. If there is no water in the water tank (E), the diffuser will be turned off automatically even when you press the spray button.
7. The product cannot be used if there is no water in the water tank (E).
NOTE: The mist concentration may vary slightly, which is normal. Different types of water, humidity, temperature and air velocity affect
spray intensity.
8. Before replacing with another oil, please clean the device according to the maintenance instructions.
9. Never leave water in the tank (E), when the device is not in use.
10. After working for a long time, turn it off for 60 minutes to avoid damaging the ultrasonic wave chip restart it.
ACCIDENTAL LEAK
If you accidentally knock over this device during use, follow these steps:
1. Turn off the power. Detach the device and open the top cover (B) to pour out all the remaining water from the water tank (E).
2. Gently shake the device to drain the internal water through the drainage hole (J) in the base.
3. Air dry the device in a safe place for 24 hours.
DESCALING
If the aroma diffuser has scale sediment caused by water, can add white vinegar to the water to dissolve the scale and then rinse with
water. Then, use soft cloth to wipe the water. Never use strong cleansing agent.
TROUBLESHOOTING
If this product is not working normally, please follow these steps for self- troubleshooting before sending the return to the seller:
PROBLEM 1: The product automatically turns off in one second when the spray button "MIST" G1 is turned on.
POSSIBLE CAUSE: Inadequate amount of water.
7
Publicidad
