Publicidad
Idiomas disponibles
Idiomas disponibles
Instruction manual
17" TO 42" TV STAND
Before using the product, read the following instructions.
The information shown in this manual serves only as a reference for the product. Due to updates there may be differences. Please
check our website www.steren.com for the most recent version of this manual.
PLACING ARMS
Place the arms (B) in each corner of the TV stand base and fix them with the
nuts (G) and the screws (F) in the order shown.
Use a screwdriver and an 8mm spanish key to tighten the pieces
TV SCREEN INSTALLATION
Do not install screens larger than 42 "or weighing more than 15 kg
Use 4 screws (C) and the 4 washers (D) to fix the TV stand on the back of the screen.
The screws supplied are standard
sizes. We recommend you consult
the instruction manual of your
screen to obtain information about
the screws needed to mount it in a
support
TV
TV
TV
CONTENT
A
(1 TV Stand)
M4X16
C (4 screws)
V2.2
M5
1018m
G (8 nuts)
STV-034
NECESSARY TOOLS
ADJUSTMENTS
1
Loosen the lock of the knob.
2
Tilt the screen to obtain the desired view angle.
3
Tighten the lock of the knob again until the TV stand is fixed.
CAUTIONS
• Choose a solid and smooth wall to securely fix the stand.
• Do not over tighten the screws.
• This product is designed for indoor use; using it outdoors could cause personal injuries and failures.
• Avoid falling device, as it could be damaged.
• Do not exceed of 15 kg maximum weight capacity.
• This device is not intended for use by people (including children), whose physical, sensory or mental
abilities are different or reduced, or who lack experience or knowledge.
• Children should be supervised to ensure they do not use the device as a toy.
B (4 arms)
M5X15
2"
M5X10
D (4 washers)
E (2 screws)
F (8 screws)
Only for VESA 200 x 200
2"
M6X16
M6
H (2 anchors)
(4 screws)
(4 washers)
1 2
1 1
1 3
PREPARATION FOR INSTALLATION
LLocate the place * where you want to install the TV stand; Place it on the surface to make sure that
1
the installation will be correct and verify that it is level using the central bubble of the leveler.
2
Make the drilling marks.
* Make sure there are no hidden pipes with electrical wiring, gas or water.
TV STAND INSTALLATION
a) On concrete
1
Use a 10 mm drill bit to drill on the marks that you made, at a depth of 2 ".
50.9 mm
(2")
ø 10mm
(ø 3/8")
Drill
Insert the anchors (H) in the holes. Mount the bracket and fix it with the screws (E).
2
E
H
b) On wood
1
Use a 3 mm drill bit to drill on the marks that you made, at a depth of 2 ".
50.9 mm
(2 " )
ø 3 mm
Drill
Mount the support and fix it with the screws (E).
2
E
A
A
Publicidad
