• The bike is fit for one person. The bike can be only used by one person at a time.
• Make sure that the child is wearing proper shoes and a helmet fit for the child and protective
pads (elbow pads, knee pads, etc.). Make sure that the shoes fit properly and have no loose ele-
ments, for instance, laces, that may get caught in the elements of the bike.
• It is advised to use high-visibility items.
• It is crucial to make sure that while riding the bike child do not take their hands off the handles.
Riding a bike with no handlebars can cause serious injuries for the child.
• Not suitable for children under 3 years of age.
• The bicycle does not have a brake.
COMPONENTS:
A. Fork of the handlebar
B. Frame
C. Saddle height adjustment hoop
D. Footrests
E. Wheels
F. Handlebar
G. Seat
H. I. J. K. L. Handlebar mounting hoops
M. Hex key
N. Screws for wheel mounting
O. Screw cap
P. Screw for handlebar mounting
INSTALLATION:
1. Insert the wheel in the holes in the frame's rear end. Next, place screws in the holes from the
outside, and turn them with a hex key to maximum resistance (fig. 4)
2. Place the hoops on the fork of the handlebar in the following sequence: H, I, J, K, L as seen in the
illustrations (fig. 5, 6, 7, 8, 9).
3. Place the fork of the handlebar in the hole located in the front part of the frame.
4. Place the rest of the hoops in the fork in the following sequence: L, K, J, I, H (fig. 10).
5. Place the handlebar on the very top of the fork as seen in fig. 11. Insert the screw (P) in the hole
placed in the handlebar and turn it with the hex key. Next, place a cap on the turned screw (O).
6. Place the front wheel in the holes placed in the fork. Next, put the rest of the screws in the holes
and turned them with the hex key to the maximum resistance (fig. 13). To make installation of the
front wheel easier you can turn the bike so that the handlebar is on the floor.
7. Loosen the screw in the saddle's mounting hoop (C). Next, install the saddle by inserting a tube
into the frame (fig. 14). Adjust the height of the saddle to the height of your child. A correct
position is when both feet of a sitting child comfortably reach the floor. Next, turn the screw to
the maximum resistance.
ATTENTION: Before a child starts using the product make sure that all the screws are secured tightly.
ATTENTION: Make sure to check and turn all the screws in the bike regularly.
NOTE: Make sure your child uses protective measures such as a helmet, elbow pads, knee pads and
appropriate footwear.
PRODUCT MAINTENANCE:
• The condition of the bicycle should be checked regularly.
10
EN