Herschel CL-200 Instrucciones De Instalación página 7

ENGLISH
Installation Guide for Herschel Inspire Units
Assembly Kit
Please check the enclosed assembly kit consists of: 2x fixings brackets, 8x screws, 8x rawlplugs
Step 1
The distance between the two mounting points of
each panel is half the length of the panel. (e.g. 750W
panel is 90cm long, so mounting points are 45cm
apart). Mark these two points on the wall where
you want the heater to be mounted and using the
supplied mounting plates, mark the eight drilling
holes on to the intended installation site.
Step 2
Drill holes in to the installation site on the marked places and then place the wall plugs in to the drilling
holes.
Step 3
To fix the included fixing brackets to the installation
site turn the screws in as far as possible through the
grooves of the fixing brackets in to the wall plugs.
Step 4
Before placing your Herschel far infrared heater
panel on to the fixing brackets please check that the
four distance pieces on the rear of the far infrared
heater panel are screwed in as far as possible.
Step 5
Now fit the far infrared heater panel on to the two
wall holders. If ceiling mounting please use the
narrower slide-in channel.
Step 6
Unscrew the four distance pieces on the rear of the
far infrared heater panel so that the panel is fixed
securely to the wall or ceiling and cannot be
removed.
Step 7
Please check that your Herschel far infrared heater panel cannot be removed from the wall.
Removal
Screw the four distance pieces so that your Herschel far infrared heater panel can be removed from the
fixing brackets and taken down from the installation site.