Publicidad
R
MAINTENANCE CHART - RECOMMENDED SERvICE INTERvALS (CONT'D)
HOURS
BREAk-IN
8
40
(FIRST 10)
7.2
LUBRICATION
GREASE FITTING LUBRICATION CHART (SEE FIGURE 7-1)
LOCATION
1 Caster Wheel Pivot *
2 Caster Wheel Bearings
3 Cutter Deck Bellcranks
4 Cutter Deck Pusharms
5 PTO Spindle
6 Cutter Deck Spindle
7 Brake Handle
8 Cutter Deck Drive Shaft U-Joints
9 Cutter Deck Drive Shaft Slip Sleeve
+ Compatible Greases:
* PROCEDURE: Remove grease cap, part number 481559. Remove plug, part number 482028-01, and install grease
zerk. Apply grease to the fitting until new grease appears at the top of the caster extension. Remove the grease
zerk and reinstall the plug. Reinstall the grease cap. Special tool, part number 47007, is recommended for use in the
installation of the grease cap.
100
200
500
Apply grease to fittings
X
Check hardware for tightness
X
Change engine oil filter
X
Check hydraulic oil level
X
Replace engine fuel filter
X
Drain hydraulic system and replace
X
hydraulic oil
Replace hydraulic oil filter
X
Replace cutter deck gearbox
X
lubricant
Change coolant
X
LUBRICATION INTERvAL
500 Hours/Yearly
100 Hours/Monthly
100 Hours/Bi-Weekly
100 Hours/Bi-Weekly
40 Hours/Weekly
40 Hours/Weekly
200 Hours/Monthly
200 Hours/Monthly
40 Hours/Weekly
Mobilix #2 found at Mobil Service Stations
Ronex MP found at Exxon Service Stations
Super Lube MEP #2 & Super Stay-M #2 found at Conoco Stations
Shell Alvania #2 found at Shell Service Stations
Lidok EP #2 found at industrial shops
Timken Lithium Multi-Use #2 found at industrial shops
PROCEDURE
LUBRICANT
Chassis Grease
Chassis Grease
Chassis Grease
Chassis Grease
+Lithium MP White Grease 2125
+Lithium MP White Grease 2125
Chassis Grease
Chassis Grease
Chassis Grease
32
Section 7
COMMENTS
See paragraph 7.2
See paragraph 7.4
See paragraph 7.3
See paragraph 7.5
Use SAE 20W50 Motor Oil.
See paragraph 7.3
See paragraph 7.3
See paragraph 7.11
See paragraph 7.11
NO. OF
PLACES
2
2
4
2
1
3
1
2
1
Publicidad
