Publicidad
Idiomas disponibles
Idiomas disponibles
W
X
1. Carefully unpack all items from the box. Place the base in the final position. There must
be a minimum of 60.96 cm / 24 inches of clearance from the side of the table top to any
combustible walls.
2. Attach the burner cover protective ring to the table top by using two ST4.2x16 mm screws
as shown in Figure 2. Do not over tighten.
3. Place the firepit tabletop onto the firepit base. Secure the tabletop to the firepit base by
using the 1/4 x 20 mm bolts and washers that are provided. See Figure 3.
4. Place the burner pan protective ring into the firepan/burner assembly as shown in
Figure 3. Align the holes in the burner pan protective ring with the pre-drilled holes on the
firepan/burner assembly. Secure the burner pan protective ring to the firepan/burner
assembly by using the three M4 screws as shown in Figure 4.
FIREPIT TABLE TOP
BURNER COVER
PROTECTIVE RING
INSTALLATION
Figure 2
6
FP2966
FP2967
Figure 3
Figure 4
1
1
Publicidad
