Panasonic KX-TGA815EXA Manual De Instalación página 5

TGA671EX(ex).book Page 5 Thursday, December 1, 2016 4:07 PM
Battery installation/Battery charging
When the language selection is displayed after installing the batteries for the
first time, you can select your desired language.
{r}: Select your desired language. s M s {ic}
Important:
• Use the supplied rechargeable batteries. For replacement, we recommend
using the Panasonic rechargeable batteries noted in the base unit's operating
instructions.
• Wipe the battery ends (S, T) with a dry cloth.
• Avoid touching the battery ends (S, T) or the unit contacts.
• Confirm correct polarities (S, T).
• USE ONLY Ni-MH batteries AAA (R03) size.
• Do NOT use Alkaline/Manganese/Ni-Cd batteries.
Place the handset on the charger for about 7 hours before initial use.
Note:
• The handset display may show "Please wait for 1 minute." when the
handset is placed on the charger if it is not registered to the base unit.
• If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends ( ,
S T
charge again.
Display language
1
K/1 (middle soft key) (11)
2
{r}: Select your desired language. s M s {ic}
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold {ic} for
few seconds to turn the handset on.
1
Handset:
Lift the handset and press {ic}.
2
Base unit:
Press and hold {x} for about 5 seconds.
• Depending on the base unit, a registration tone sounds.
• If all registered handsets start ringing, press {x} again to stop, then repeat
this step.
(page 2: 2)
) and the charge contacts with a dry cloth and
5